Everything works, and can be run upon request.  We can load the machine for you, but you will need to pick it up, or pay to have it crated and shipped.

I will personally give you 1 hour of free technical support and help you setup the machine at your shop if you are located within 1 hour drive time of Blissfield, MI.  If you live outside this range, we can come up with another arrangement.

This system comes complete with everything you need except an air compressor.

This system includes:
A. 5' X 10' Koike Aronson Plasma Water Table
B. Hypertherm PowerMax 85 Machine Torch with consumables
C. Computer with LIBRECAD, SHEETCAM, and MACH4
D. Brand New EC01 Controller
E. Brand New (2) Maxsine EP5 Servo Motors and Drivers
F. Brand New (2) 10A Air Circuit Breakers, (2) WEG Overload Relay Contactors, (2) EMI Filters
G. Brand New 24V Power Supply
H. Brand New (4) Large Cooling Fan with Covers
I. Brand New (2) Servo Shaft Adapters
J. Custom Milled Servo Motor Adapters

This machine was retrofit from a Koike Aronson D10 and is now essentially a BRAND NEW plasma table.

To run the machine you will need (1) 110v connection for the computer and controller.  You will also need (2) 220v single phase connections (1 for the servos and 1 for the plasma cutter), preferably not on the same circuit. This is so that the plasma torch doesn't trip the breakers in your building when you are cutting at 85 amps and running the servos at the same time.

Price is $10,000.

Call us at 517-486-4591

 Images below